By U.S. Army Combat Readiness Center
Special to GUIDON
Vehicle water crossings are an inevitable yet necessary task for leaders, Soldiers and personnel to accomplish their missions.
Because of the inherent danger in water crossings, it is imperative units conduct proper terrain analysis, personnel training in fording operations, equipment preparation and apply risk management during the planning process and well before the execution phase.
Soldiers and leaders may not realize the buoyant force on an object is equal to the weight of the fluid displaced by that object.
A cubic foot of water weighs about 62 pounds. Vehicles displace a lot of water when they enter a river or creek bed, and the pressure exerted by moving water increases with the square of its velocity.
The depth and width of the area to be crossed, the bank conditions and the river’s current velocity are major factors to consider before attempting a water crossing.
These factors will determine if equipment and personnel can cross by fording or swimming.
Some common risks include vehicles stalling or becoming stuck. Most times, when a vehicle stalls, personnel try to get out of the vehicle. Once outside, however, they are exposed to swift currents that may result in them falling into the water and being swept away or jammed into debris downstream.
Drivers and their vehicle commanders must be aware of environmental conditions and other issues associated with water crossings.
Water clarity and lighting circumstances could conceal the condition of the roadway beneath them. Floodwaters can also hide a damaged roadway. Generally, flash floods do not last more than an hour, so Soldiers should keep this in mind: Do not trade a lifetime for an hour. Act safely; remember your training, and do not cut corners.
— Follow all vehicle fording and swimming instructions in accordance with the vehicle’s technical manual.
— During training exercises, ensure drivers and crewmembers wear personal flotation devices if the water is more than 4 feet deep.
Factors to consider during water-crossing operations include:
— Ensure the water depth at the fording site is below the vehicle’s fording limits and the site is clear of submerged obstacles.
— Do not exceed 4 mph when entering and traveling through the water.
— Consider not wearing load-bearing equipment during fording operations. The equipment could snag on vehicle components and prevent crewmembers from escaping through the top hatches during emergencies.
— Consider leaving combat locks unlocked during fording and when operating near bodies of water.
— Store sensitive items and small arms inside the vehicle. If the vehicle sinks, these items can be easily retrieved during recovery operations.
— Attach dismounted troops to a safety line when crossing.
— Do not cross more than one vehicle at a time, and do not cross a vehicle beside dismounted troops.
— Ensure the fording site has adequate entrance and exit points and a firm bottom.
(Editor’s note: this article was written by the Directorate of Assessments and Prevention, Ground Division out of Fort Rucker, Alabama.)